GRAPHTEC CE6000 SERIES - Page 151

CE6000-UM-251-9370 9-8
9 TROUBLESHOOTING
E04014 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04015
It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04016
It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04017
It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04018
Media set lever was lowered. Reload the media and try again.
E04019
There was cancel operation by the
user.
Redo the process.
E04020
There is a defect in the detection
settings value.
Check the settings value.
E04021
Registration mark was not
detected in the auto detection
area.
Check the media. Check the print
position of the registration mark.
E04022
There was cancel operation by the
user.
Redo the process.
E04023
Registration mark was not
detected.
Redo the sensor level adjustment.
Change the color of the
registration mark.
Check the media.
Check the print position of the
registration mark.
E04024
Registration mark was not
detected.
Redo the sensor level adjustment.
Change the color of the
registration mark.
Check the media.
Check the print position of the
registration mark.
E04025
Registration mark was not
detected.
Redo the sensor level adjustment.
Change the color of the
registration mark.
Check the media.
Check the print position of the
registration mark.