GRAPHTEC CE6000 SERIES - Page 153

CE6000-UM-251-9370 9-10
9 TROUBLESHOOTING
E01017 There is heavy load on the media
moving direction.
or
The media is too heavy to feed.
or
The media stopper is not released.
or
The cutting speed is too fast.
or
The X motor is defective.
or
The main board is defective.
Move the object disturbing the
operation, and turn on the plotter
after turning it off once.
or
Do not use heavy media.
or
Use the pre-feed function.
or
Release the media stopper.
or
Reduce the cutting speed.
or
Replace the X motor.
or
Replace the main board.
E01019
Load on the Y motor was too
large.
or
The blade length is too long.
or
The Y motor is defective.
or
The main board is defective.
Move the object disturbing the
operation, and turn on the plotter
after turning it off once.
Do not use heard media.
or
Adjust the blade length.
or
Replace the Y motor.
or
Replace the main board.
E01021
Load on the motor was too large.
or
The blade length is too long.
or
The X or Y motor is defective.
or
The main board is defective.
Move the object disturbing the
operation, and turn on the plotter
after turning it off once.
Do not use heavy media or heard
media.
or
Adjust the blade length.
or
Replace the X or Y motor.
or
Replace the main board.
E01022
There was a heavy load on the
up and down function of the tool
carriage.
The pen block is defective.
or
The main board is defective.
Clear any obstruction in the up
and down function of the tool
carriage and turn the power back
on.
or
Replace the pen block.
or
Replace the main board.
E05001
Data lager than the buffer size can
not be copied
Perform normal cutting by sending
the data mode.
E05002
There is no data to copy. Perform normal cutting by sending
the data then use the copy mode.
E05003
Media valid area to copy is too
small.
Use larger media.
Confirm the copy starting position.
E05004
The push roller is not on the grit
roller.
Set the push roller on the grit
roller.