CE6000-UM-251-9370 6-36
6 DISASSEMBLY AND REASSEMBLY
(9) Remove the two M3L6 binding screws holding the X-drive roller bearing with a bearing stopper
ange.
M3L6 binding head screw
Flange
(10) Remove the bearing from the X drive roller shaft, and then slide out the X-drive roller from the
unit.
How to reinstall the drive roller
(1) Reattach in the reverse order in which it was detached.
(2) Spread a suitable quantity of Loctite 222 on the M3L4WP set screw holding the X-drive pulley.
(3) Use the force gauge to pull the X-drive motor pulley ange with a 1.8 kg to 2.0 kg force.
(4) Tighten the mounting screws that hold the X-motor.
(5) Spread a suitable quantity of the Shinetu silicon grease G501 on the X-motor pulley.
(6) Move the X-drive pulley and check the tension of the X-drive belt.
(7) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
