CE6000-UM-251-9370 6-41
6 DISASSEMBLY AND REASSEMBLY
The bottom part of Y-rail has to touch to the side panel plate and the front part of Y-rail has to touch to
the side panel plate when installing the Y-rail.
The push roller will not become to the center of the drive roller if the front part of Y-rail does not touch
to the side panel plate.
And the height from the push roller and the drive roller will not become same height at right and left if
the bottom part of Y-rail does not touch to the side panel plate.
How to adjust Y-rail mounting position
(1) The Y rail is holding by the Y motor bracket and the Y idler pulley bracket.
(2) Lift up the push rollers.
(3) Loosen the screws holding the Y motor bracket and the Y tension bracket, and then adjust the
position for the Y rail.
(4) Tighten the screws after the Y rail position is adjusted.
To Next Page
Loading...
