GRAUPNER mz-18 HoTT User Manual

- RX FAIL SAFE
• OUTPUT CH/ INPUT CH
You may edit and adjust transmitter channel which is connected with a receiver using “OUT-
PUT CH” and “INPUT CH”. Receiver CH1, 2, 3, 4, 5, 6 are connected to the same channels of
transmitter as the default and you may edit the channel connection of receiver and transmitter.
Since OUTPUT CH is changed if INPUT CH would be changed, we recommend that you
would change INPUT CH.
• MODE
It is used to select the failsafe type. “HOLD” is basically set in all the channels.
Touch “SET” icon to activate the value in red then you may select HOLD or OFF or FAIL SAFE
with INC and DEC buttons. After selecting one of HOLD, OFF and FAIL SAFE, touch “SET”
icon again to deactivate the value. Touch INC button to move the cursor to “F.S.POS”
Touch INC button to move the cursor to “INPUT CH” and touch “SET” icon to activate the value in
red then select the channel to be connected to “OUTPUT CH” with INC and DEC buttons. Touch
“SET” icon again to deactivate the value. Touch INC button to move the cursor to “MODE”
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
57

GRAUPNER mz-18 HoTT Specifications

General

Brand	GRAUPNER
Model	mz-18 HoTT
Category	Remote Control
Language	English