The GRIT system does not require internet access to operate, however, in order to
access your system remotely and to perform updates, internet access is required and
recommended. The two options of accessing the Hub are:
Connect with the Hub via your own local network, or;
Connect with the Hub via its own projected Wi-Fi*
Select a location for your Hub that:
is centrally located in your shop to support good connectivity with other devices.
is located near an ethernet connection or close to your personal Wi-Fi port (if
applicable).
is located near a 120v outlet.
After considering the best location for your Hub, plug in the Hub using the provided power
supply. Allow the Hub to boot up (can take up to 2 minutes). A QR code is visible on the
side display when the Hub is ready for connection.
Next, choose the connection method you'll be using: Ethernet or the Hub's own Wi-Fi*.
*Note: If planning to connect with your own private Wi-Fi, choose the initial setup option
that first connects with the Hub's Wi-Fi. Information on how to switch to a connection with
your own private Wi-Fi will be covered in the GRIT Hub® + App section.
GETTING STARTED
Getting Started
Initial Setup
The GRIT Hub® is the "brains" of the system and
should be installed first.
17
Getting Started
To Next Page
Loading...