TRIGGERS
This particular drill press has a light
that draws about .5 Amp when the
trigger is unlocked but the tool is not
yet running.
If there is an aspect of the tool that
draws power even when it is not
running, be sure to set the Activation
Level above that amp level. This is to
avoid the system thinking the tool is
running when it is merely operating
other components (i.e., a light, a
computer, etc.).
Note: Some incandescent lights
actually pull a great amount of power
when they are turned on from a cold
state. Keep this in mind when setting
your Activation Level.
Light On
Tool Running
54
To Next Page
Loading...