GST GST5000 - Instructions for System Operator; Self Test; Printer Setting

GST5000 Intelligent Fire Alarm Control Panel
Installation and Operation Manual (Generic Part)
The Intelligent Solution
Page 44
Fig. 6-2
6.3 Instructions for System Operator
6.3.1 Self Test
In normal monitoring state, pressing SELF TEST, you can check all the audio and visual
components.
6.3.2 Printer Setting
The printer can be set to 3 modes. Pressing PRINT (needing password if the keypad is
locked) in monitor state, the system is shown like Fig. 6-3.
Fig. 6-3
History
12//06//10:45 000000 CRTFault Fault
12//06//10:40 000000 Reset
12//06//10:37 000000 AC Fault Back
12//06//10:28 000000 AC Fault Fault
12//06//10:20 010032 CableDet Fire
12//06//10:11 010056 HR Pump Start
12//06//10:05 020011 Sounder Act
12//06//10:01 030124 Heat Det Iso
Press Enter to select an item
History
12//06//10:45 000000 CRTFault Fault
12//06//10:40 000000 Reset
12//06//10:37 000000 AC RCL Back
12//06//10:28 000000 AC Fault Fault
12//06//10:20 010032 CableDet Fire
12//06//10:11 010056 HR Pump Start
12//06//10:05 020011 Sounder Act
12//06//10:01 030124 Heat Det Fire
Press ENTER to print Highlight item
Ve
r
V
4
.05f
Print mode setup
1. Disable
2. History
3. Only fire