GST5000 Intelligent Fire Alarm Control Panel
Installation and Operation Manual (Generic Part)
The Intelligent Solution
Page 47
6.4 Instructions for System Administrator
Pressing SYSTEM can enter system setup menu. This menu contains password setting
and other functions for commissioning, including "Modify password", "Communicate
setup", "Working state setup", "Fire display mode", "Zone browser", "C&E browser" and
“Monitoring device”. Refer to Fig. 6-7.
Fig. 6-7
6.4.1 Password Modification
1 Access level:
After the function keys (except for SELF TEST, MUTE, LOG, VIEW FIRE, VIEW FAULT,
VIEW DISABLE and VIEW PLANT) are pressed, the system will display a screen
requiring a password. Only after the correct password is input can a further operation be
done.
User password: for printer setting, clock setting, security mode setting, start/stop,
disable, enable and the operation on ZCP and FACP reset.
Gas extinguishing control password: for gas release enable control.
System password: Entering SYSTEM menu for setting of system state and data.
Higher-level password can substitute for lower-level password. System password must
be entered for system operation. It becomes invalid on exit after certain operations are
finished. Input password for other operations.
2 Password Modification
In system setup menu like Fig. 6-7, selecting the first item "Modify password", the
screen will display the three levels of password, as shown in Fig. 6-8.
Ver V4.05
To Next Page
Loading...
