GST5000 Intelligent Fire Alarm Control Panel
Installation and Operation Manual (Generic Part)
The Intelligent Solution
Page 52
Chapter 7 Commissioning Functions
The commission mode is set for system commissioning, including registering devices,
loop card disablement and detector searching functions.
NOTE: Under commission mode, all the registering information will not be saved.
When the FACP is restarted, the missing or damaged devices will not be reported.
These functions are only for commissioning.
7.1 Getting into Commission Mode
Enter system setup menu (Fig. 6-7), select “3.Working state setup” (Fig.7-1):
Fig. 7-1
Press "
△
＝
" and "
＝
▽
", select 2 "Commissioning State", confirm to enter commissioning
state, the word "Installer" will appear on top of the screen. The screen shows as in Fig.
7-2.
Fig. 7-2
Ver V4.05
To Next Page
Loading...
