GUDEL FlexxPump 402 - Control Elements; Fig. 4 -5 Magnetic Peg

Digit display
The digit display serves for communication.
LED
The LED indicates the function:
• The green and red LEDs glow for 5 seconds after activation to check their
own status
• The green LED glows during the lubrication cycle
• The green LED flashes if there is no error
• The red LED flashes every 5 seconds if there is an error
Fault message
The fault message shows the type of error. More detailed information
Ü2106
4.2.2.4 Control elements
The magnetic peg is magnetic and integrated into the vent locking mechanism.
Remove the vent locking mechanism to use the magnetic peg. Touch the ac-
tive surface with it to perform the following actions:
• Switch the FlexxPump on and off
• Set lubrication cycle
• Perform functional check
D003499
A
C B
Fig.4-5 Magnetic peg
A Vent locking mechanism
B Active surface
C Magnetic peg
Design, function
OPERATING MANUAL Automatic lubrication system
FlexxPump 402 / 402B
90071992656444683_v9.0_EN-US
40