GUDEL FlexxPump 402 - Basics; Table 6-1 Average Lubricant Requirement Per Lubrication Point (U)

6.4.1.2 Basics
Average lubricant
requirement at a
lubrication point
(U)
The following lubricant quantities should be dispensed at least per lubrication
point. These are empirical values from Güdel. These values can be met only
approximatively due to the number of outputs of the pumps and the installed
splitters.
Size Average lubricant requirement
per lubrication point (U)
1-5 0.30cm
3
/ 100km
6-7 0.40cm
3
/ 100km
Table6-1 Average lubricant requirement per lubrication point (U)
Recommended lu-
brication quantity
(P
t
)
The recommended lubrication quantity P
t
can be found in the following table.
System Size 1-5 Sizes 6-7
3 lubrication points
(e.g. EP, TMF, TMO)
0.9cm
3
/ 100km 1.2cm
3
/ 100km
6 lubrication points
(e.g. ZP)
1.8cm
3
/ 100km 2.4cm
3
/ 100km
4 lubrication points
(e.g. X-axis FP)
1.2cm
3
/ 100km 1.6cm
3
/ 100km
Table6-2 Recommended lubrication quantity (P
t
)
Operation
OPERATING MANUAL Automatic lubrication system
FlexxPump 402 / 402B
90071992656444683_v9.0_EN-US
66