GW Instek GDM-8261A - Page 117

SCANNER (OPTIONAL)
117
4. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
HOLD TRIG
Range
101 ~ 118
5. When finished, press the Enter
key. The End (Maximum)
channel setting appears.
AUTO
ENTER
6. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
HOLD TRIG
Range
101 ~ 118 (must be greater than or equal
to the Start (Min) channel)
7. When finished, press the Enter
key. The Timer setting appears.
AUTO
ENTER
8. Move the cursor to the timer
setting using the Left/Right key,
and change the value using the
Up/Down key.
HOLD TRIG
Range
1ms ~ 9999ms
9. When finished, press the Enter
key. The Count setting appears.
AUTO
ENTER
www. .com
information@itm.com1.800.561.8187