GDM-8261A User Manual
136
1. Press the Shift key, the 2nd
(Menu) key, the left key
repeatedly until the TX TERM
configuration menu appears.
2. Press the Down key and then
the Right key. The SEP selection
display appears.
3. Press the Down key. The SEP
selection menu appears.
4. Press the Up/Down key to
select the separation character.
5. Press the Enter key followed by
the Exit key. The SEP setting is
stored and the display goes back
to the default display.
When the VAL1?, VAL2?, TRACe:DATA? and FETCh?
queries are used, the return measurement format can be
configured in one of four ways: V (value), V+U (value,
unit), V+C (value, count#), V+U+C (value, unit,
count#). See page 199 and 199 for usage examples.
Note: The READ? query will not return values based on
the return format settings, see page 198 for details.
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
