GW Instek GDM-8261A - Configure RS-232 C Interface

REMOTE CONTROL
133
3. Press the Down key. The USB
ON/OFF selection appears.
4. Press the Up/Down key to
select ON or OFF.
5. Press the Enter key followed by
the Exit key. The USB setting is
stored and the display goes back
to the default display.
AUTO
ENTER
/ EXITSHIFT
6. Connect the USB cable to the
rear panel terminal (upper port).
CAL KEY
Configure RS-232C Interface
Configuration
step
1. Press the Shift key, the 2nd
(Menu) key, and then the left key
repeatedly until the I/O
configuration menu appears.
/ EXITSHIFT
2ND
MENU
HOLD
2. Press the Down key and the left
key repeatedly until the RS232
selection display appears.
HOLD
3. Press Enter or Down to confirm
RS232 selection.
AUTO
ENTER
or
www. .com
information@itm.com1.800.561.8187