GW Instek GDM-8261A - Measurement Configuration Settings; D-Shift Settings

GDM-8261A User Manual
84
4. Select the level using the
Up/Down key.
5. Press the Enter key to confirm
your selection. Press the Exit
key to go back to the default
display.
AUTO
ENTER
/ EXITSHIFT
Measurement Configuration Settings
D-Shift Settings
Background
The D-Shift setting automatically shifts the decimal point
depending on the measurement. If D-Shift is turned off,
the measured readings will be displayed at the full 6
2
1
digits with a fixed decimal place. The D-Shift setting is on
by default.
D-Shift
On, Off (default, On)
Panel operation
1. Press the Shift key, the 2nd
(Menu) key followed by the
Right key. The MEAS menu
appears.
/ EXITSHIFT
2ND
MENU
TRIG
2. Press the down key, followed by
the right key twice to enter the
D-SHIFT menu.
TRIG
TRIG
3. Press the Down key. The
D-Shift setting appears.
www. .com
information@itm.com1.800.561.8187