1. Press the Shift key, the 2nd
(Menu) key, the left key
repeatedly until the TX TERM
configuration menu appears.
2. Press the Down key. The EOL
menu appears.
3. Press the Down key. The EOL
selection menu appears.
4. Press the Up/Down key to
select the EOL character.
5. Press the Enter key followed by
the Exit key. The EOL setting is
stored and the display goes back
to the default display.
Set the Separation Character
The TX TERM configuration menu can set the
separation character for multiple return measurement
values, the GPIB’s separation character is fixed as a
comma. While the separation character for LAN can be
either CR+LF or a comma.
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
