GW Instek GDM-8261A - Auto-Gain

GDM-8261A User Manual
90
1st display
Shows A-Zero setting
3. Select the setting using the
Up/Down key.
4. Press the Enter key to confirm
your selection. Press the Exit
key to go back to the default
display.
AUTO
ENTER
/ EXITSHIFT
Auto-Gain
Background
The Auto-Gain (A-GAIN) setting performs auto gain
correction of the internal amplifiers.
Setting
Off, On (default=On)
Applicable
Measurement
Mode, Rate and
Speed settings
Mode
Rate
Accuracy Speed
Quick Speed
DCV, DCI,
4W/2W,
Resistance
S


M

F

Mode
Rate
TC, RTD,
Diode,
Cont
S
These four measurement modes don’t
support either accuracy or quick speed.
M
Panel operation
1. Press the Shift key followed by
the 2nd (Menu) key. Press the
right key twice to choose the
SET ADC menu.
/ EXITSHIFT
2ND
MENU
TRIG
TRIG
www. .com
information@itm.com1.800.561.8187