2. Press the Right key, then the
down key. Press the left key. The
Current detect menu appears.
3. Press the Down key. The input
current detect setting appears.
Shows the current detect setting
4. Select the setting using the
Up/Down keys.
5. Press the Enter key to confirm
your selection. Press the Exit
key to go back to the default
display.
The Auto Zeroing (A-Zero) function can be used in
resistance, TC, RTD, DCV and DCI measurements.
Auto zeroing is used to prevent measurements from
drifting by taking offset measurements.
The combined offset from the input buffer, A/D driver
and ADC is called the total offset. Due to temperature
variations inside the GDM-8261A, the offsets for the
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
