GDM-8261A User Manual
120
Run Scan
Overview
Measures all the specified channel ranges
at each trigger event. The timer settings
(page 115) apply to each scan.
Measures a single channel in the specified
range at each trigger event. The timer
settings (page 115) apply to each channel.
Continuously measures one channel.
1. Press the Shift key followed by
the ACV key (Scan) or DCV key
(Step).
2. The STO indicator turns On. The Scan (Step) starts
running and the data is recorded. After running the
predefined count, the Scan (Step) stops running.
To run the Scan (Step) again, press
the Trig key. The previous data is
overwritten by the new Scan.
To abort Scan/Step or to go back to
the normal display, press the Shift
key followed by the ACV key (Scan)
or DCV key (Step) again.
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
