GW Instek GDM-8261A - Compare Measurement

ADVANCED MEASUREMENT
65
Compare Measurement
Applicable to
ACV
DCV
ACI
DCI
2/4W
Hz/P
TEMP
Background
Compare measurement checks and updates if the
measurement data stays between the upper (high) and
lower (low) limit specified.
1. Activate
Compare
measurement
Press the Shift key, then the Hold
(Comp) key.
/ EXITSHIFT
HOLD
COMP
2. High limit
setting
V
1st display
Shows the high limit value
2nd display
Indicates high limit setting
1. Use the Left/Right key to move
the cursor (flashing point)
between high/low setting, digits,
and decimal point.
HOLD TRIG
2. Change the parameter using the
Up/Down key.
3. Press the Enter key to confirm
editing and move to the low
limit setting.
AUTO
ENTER
www. .com
information@itm.com1.800.561.8187