2. Press the Down key and the
Left key repeatedly until LAN
selection display appears.
Note: The LAN menu will be
selectable only when the LAN
card is installed.
3. Press the Down key. The LAN
ON/OFF selection appears.
4. Press the Up/Down key to
select ON or OFF. ON will turn
the LAN option on, OFF will
turn the LAN option off.
Note: Ethernet configuration
settings can only be edited when
LAN is set to ON.
5. Press the Enter key followed by
the Exit key. The Ethernet port
is turned on/off and the display
goes back to the previous
display.
6. Connect the Ethernet cable to
the rear panel Ethernet port
after the Ethernet card has been
installed (page 141).
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
