Return to Initial
Settings
1. Press the Shift key, the 2nd
(Menu) key, and the Left key
repeatedly until the SET LAN
configuration menu appears.
Note: SET LAN will only be
available after LAN has been
activated in the I/O menu, see
page 142.
2. Press the Down key and then
the Right key repeatedly until
the INIT selection display
appears.
3. Press the Down key. The INIT
NO/YES selection appears.
4. Press the Up/Down key to
select NO or YES. YES will
return the Ethernet settings
back to the initial settings, NO
will cancel returning to the
initial settings.
5. Press the Enter key followed by
the Exit key to confirm the
settings and exit from the
configuration menu.
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
