2nd
Measurement
item setting
Press the 2nd key, then the target
item (example: ACV). The display
updates the measurement result.
(example: ACI + ACV)
Shows the primary measurement result
Shows the secondary measurement
result
Indicates that dual measurement is
active
Editing 1st or
2nd
measurement
item settings
After the secondary measurement function has been
activated, the rate, range and measurement item can be
edited for either the primary or secondary display. Note
however, it is more practical to configure the first or
second measurement items before activating dual
measurement mode.
Toggle whether the primary or
secondary display is the active
display by pressing the 2ND key:
Primary display: 2ND is not
visible on the display
Secondary display: 2ND is
visible on the display
Do not hold the 2ND key. This will turn
the dual measurement off.
2. Edit active
display settings
Edit the range, rate or measurement
item for the active display in the
same way as for single measurement
operation. See the Basic
Measurement chapter for details.
To turn Off the 2nd measurement,
press and hold the 2nd key for more
than 1 second.
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
