GW Instek GDM-8261A - Page 69

ADVANCED MEASUREMENT
69
2. Change the parameter using the
Up/Down key.
3. Press the Enter key to confirm
editing and move to offset
setting.
AUTO
ENTER
3. Set the offset
(B)
V
1st display
Shows the offset (B)
2nd display
Indicates MX+B (The letter B flashes)
1. Use the Left/Right key to move
the cursor (flashing point)
between the offset, digits and
decimal point.
HOLD TRIG
2. Change the parameter using the
Up/Down key.
3. Press the Enter key to confirm
the editing. The MX+B
measurement result appears.
AUTO
ENTER
4. View MX+B
SDC
V
AUTO
MATH
m
1st display
Shows the calculated result
2nd display
Indicates MX+B
MATH
Indicates Math operation
www. .com
information@itm.com1.800.561.8187