OPERATION
53
Temperature Measurement
The GDM-8351 can measure temperature using a thermocouple. To
measure temperature, the DMM accepts a thermocouple input and
calculates the temperature from the voltage fluctuation. The
thermocouple type and reference junction temperature are also
considered.
To make temperature measurements, press
SHIFT → 2W/4W (TEMP).
The temperature mode appears showing the
temperature on the primary display and the
type of sensor on the secondary display.
GPIBCVCCSWEEPFILTRCLSTOCOMP2ND
EXTSHIFTERRLIMITAUTOMATH4W2WDCAC
mm
kM
FC
mdB
%
AVmm
HzWkM
WSFC
RMTMAXMINRELHOLDSMFAUTO4W2WDCAC
nμF
Measurement
Temp.
units
Sensor type
Connect the sensor lead between the VΩ
terminal and the COM terminal. The display
updates the reading.
1000V
750V
500Vpk
INPUT
FUSE
1.25A/1000V
V
W
SENSE
W
4W
COM
200Vpk
H I
LO
10A 1A
CAT II 600V
To Next Page
Loading...
