CONFigure:CAPacitance
Sets measurement to Capacitance on the first display.
Parameter: [None] | [Range(<NRf> | MIN | MAX | DEF)]
Example: CONF:CAP 10E-6
Sets the measurement mode to Capacitance with a 10μF Range.
CONFigure:FUNCtion?
Returns the current function on the first display.
Return parameter: VOLT, VOLT:AC,VOLT:DCAC, CURR,
CURR:AC,CURR:DCAC, RES, FRES, FREQ, PER, TEMP, DIOD,
CONT, CAP
CONFigure:RANGe?
Returns the current range on the first display.
Return Parameter:
DCV: 0 .1(100mV), 1(1V), 10(10V), 100(100V), 1000(1000V)
ACV: 0.1(100mV), 1(1V), 10(10V), 100(100V), 750(750V)
ACI: 0.01(10mA), 0.1(100mA), 1(1A), 10(10A)
DCI: 0.01(10mA), 0.1(100mA), 1(1A), 10(10A)
RES: 10E+1(100Ω) 10E+2(1kΩ), 10E+3(10kΩ), 10E+4 (100kΩ),
10E+5(1MΩ), 10E+6(10MΩ), 10E+7(100MΩ)
FRES: 10E+1(100Ω) 10E+2(1kΩ), 10E+3(10kΩ), 10E+4 (100kΩ),
10E+5(1MΩ), 10E+6(10MΩ), 10E+7(100MΩ)
CAP: 10E-9(10nF), 10E-8(100nF), 10E-7(1μF), 10E-6(10μF),
10E-5(100μF)
CONFigure:AUTO?
Returns the Auto-Range status of the function on the 1
st
display.
Return Parameter: 0|1, 1=Auto range, 0=Manual range
To Next Page
Loading...
