GW Instek GDM-8351 - Configure RS232 Interface

REMOTE CONTROL
95
Steps
1. Connect the USB cable to the rear panel type B
USB port.
2. Press MENU.
3. Go to I/O on level 1.
4. Go to USB on level 2.
5. Select USB-CDC or USB-TMC.
Display
REARGPIBCVCCSWEEPFILTRCLSTOCOMP2ND
dBmEXTSHIFTERRLIMITAUTOMATH4W2WDCAC
AVmm
HzWkM
WSFC
mdB
%
AVmm
HzWkM
WSFC
RMTMAXMINRELHOLDSMFAUTO4W2WDCAC
nμF
USB class
setting
USB menu
indicator
Configure RS232 Interface
RS232
Configuration
Selectable Baud rate
9600, 19200, 38400, 57600,
115200
Parity
None
Hardware flow control
Off
Data Bits
8
Stop bit
1
Steps
1. Connect the RS232 cable to the rear panel RS232
port.