GW Instek GDM-8351 - Digital I;O Overview

DIGITAL I/O
89
Digital I/O Overview
The Digital I/O port is a dual function port. By default (Normal
Mode) the port is used with the compare function to output Hi Fail,
Lo Fail, Pass, and EOM (end of measurement) signals. In addition
there is also a TRIG IN input pin.
As a secondary function (User Mode), the Digital I/O port can have
the output state of pins 1 ~4 controlled via remote control.
Pinout
DIGITAL I / O
H.F L.F PASS EOM
SET3SET2SET1 SET4
TRIG
IN
GND
Pin No.
Normal Mode
User Mode
1
High Fail
Set 1
2
Low Fail
Set 2
3
Pass
Set 3
4
EOM
Set 4
5
TRIG IN
TRIG IN
6
Ground
Ground