GW Instek MSO-2000EA - Freeze the Waveform (Run;Stop)

MSO-2000E & 2000EA User Manual
104
3. From the side menu choose the
graticule display type.
Full : Shows the full grid; X and Y axis
for each division.
Grid : Show the full grid without the X
and Y axis.
Cross Hair : Shows only the center X
and Y frame.
Frame : Shows only the outer frame.
Freeze the Waveform (Run/Stop)
For more details about Run/Stop mode, see page 44.
Panel Operation
1. Press the Run/Stop key. The
Run/Stop key turns red and
waveform acquisition is
paused.
Run/Stop Run/Stop
2. The waveform and the trigger
freezes. The trigger indicator on
the top right of the display shows
Stop.
3. To unfreeze the waveform,
press the Run/Stop key
again. The Run/Stop key
turns green again and
acquisition resumes.
Run/Stop Run/Stop