GW Instek MSO-2000EA - Common

MSO-2000E & 2000EA User Manual
340
Common
Vertical
Sensitivity
Resolution
8 bit
:1mV*~10V/div
*: When the vertical scale is set to
1mV/div, the bandwidth limit will be set
to 20MHz automatically.
Input Coupling
AC, DC, GND
Input Impedance
1MΩ// 16pF approx.
DC Gain Accuracy*
1mV: ±5% full scale
≥2mV: ±3% full scale
Polarity
Normal & Invert
Maximum Input
Voltage
300Vrms, CAT I
Offset Position Range
1mV/div ~ 20mV/div : ±0.5V
50mV/div ~ 200mV/div : ±5V
500mV/div ~ 2V/div : ±25V
5V/div ~ 10V/div : ±250V
Waveform Signal
Process
+, -, ×, ÷, FFT, FFTrms, User Defined
Expression
FFT: Spectral magnitude. Set FFT Vertical
Scale to Linear RMS or dBV RMS, and
FFT Window to Rectangular, Hamming,
Hanning, or Blackman-Harris.
Trigger
Source
CH1, CH2, CH3*, CH4*, Line, EXT**,
D0-D15
*four channel models only.
**two channel models only.
Trigger Mode
Auto (supports Roll Mode for 100 ms/div
and slower), Normal, Single Sequence
Trigger Type
Edge, Pulse Width(Glitch), Video, Pulse
Runt, Rise & Fall(Slope), Timeout,
Alternate, Event-Delay(1~65535 events),
Time-Delay(Duration, 4nS~10S), Bus
Holdoff range
4nS to 10S
Coupling
AC, DC, LF rej., Hf rej., Noise rej.
Sensitivity
1div
External
Trigger
Range
±15V
Sensitivity
DC ~ 100MHz Approx. 100mV
100MHz ~ 200MHz Approx. 150mV
Input Impedance
1MΩ±3%~16pF
Horizontal
Time base Range
1ns/div ~ 100s/div (1-2-5 increments)
ROLL: 100ms/div ~ 100s/div
Pre-trigger
10 div maximum