GW Instek MSO-2000EA - Manage Arbitrary Waveforms

MSO-2000E & 2000EA User Manual
238
6. Press More 1 of 2.
7. Press Span to set the frequency
span of the sweep.
8. Press Center to set the center
frequency for the configured span.
Span
Center
25Mhz ~ -25MHz
25MHz ~ 0.1Hz
Note
To configure a up sweeping, set the span with a
positive frequency. To configure a down sweeping, set
the span with a negative frequency.
Sweep Time
9. Press SWP Time to set how long
the sweep takes to go from the
start to the stop frequency.
Sweep time
5.0us ~ 10s
Manage Arbitrary Waveforms
The Arbitrary Waveform menus allow you to create, edit, recall and
save arbitrary waveforms. The menus are accessible via the
Waveform Edit button on the bottom menu once GEN1 or GEN2 has
been setup with an arbitrary waveform.
Create New ARB Waveform
Background
The Create New menu is used to load an inbuilt
waveform with a defined length in order to build
the shape of the arbitrary waveform. Supported
waveforms include: Sine, Square, Pulse, Ramp and
Noise.