MSO-2000E & 2000EA User Manual
182
14. The oscilloscope will now trigger when the
specified bus data matches the Trigger When
conditions.
LIN Bus Trigger
The LIN bus trigger conditions can be set at any time after the bus
setting has been set to LIN.
1. Set the Bus to LIN in the bus menu.
2. Press the Trigger Menu key.
3. Press Type from the bottom menu.
4. Select Others → Bus from
the side menu. The Bus
indicator appears at the
bottom of the display.
From left: Bus trigger, Trigger source
5. Press Trigger On and select the
triggering condition for the
selected bus.
Sync, Identifier, Data, Id and Data,
Wakeup Frame, Sleep Frame, Error.
6. If Identifier or Id & Data was
configured for the Trigger On
setting, press Identifier from the
bottom menu.
To Next Page
Loading...
