MEASUREMENT
41
Basic Measurement
This section describes the basic operations required in capturing,
viewing and measuring the input signal. For more detailed or more
specific operations, see the following chapters.
Advanced Configuration → from page 81
Logic Analyzer→ from page 204
Arbitrary Wave Generator (MSO-2000EA only)→ from page 220
Applications→ from page 255
Before operating the oscilloscope, please see the Getting Started
chapter, page 11.
Channel Activation
To activate an input channel,
press a channel key.
When activated, the channel
key will light up. The
corresponding channel menu
will also appear.
Each channel is associated with the color shown
beside each channel’s vertical SCALE dial: CH1:
yellow, CH2: blue, CH3: pink and CH4: green.
When a channel is activated, it is shown above the
bottom menu system.
To Next Page
Loading...
