GW Instek MSO-2000EA - SPI Bus Trigger Settings

ADVANCED CONFIGURATION
177
Press Apply Preset to set the default
address to the preset.
Note
 Presets are not available for Trigger On
Address/Data.
13. Press Address from the side menu
to manually edit the triggering
address.
To edit the address, use the
Variable knob to highlight a binary
or hex digit and press Select. Use
the Variable knob to choose a value
for the digit and press Select to
confirm.
VARIABLE
Binary
0,1, X (don’t care)
Hex
0~F, X (don’t care)
Direction
14. Press Direction on the bottom menu
and choose the direction from the
side menu.
Direction
Write, Read, Read or Write
SPI Bus Trigger Settings
The SPI bus trigger conditions can be set at any time after the bus
setting has been set to SPI.
Panel Operation
1. Set the Bus to SPI in the bus menu.
Page 130
2. Press the Trigger Menu key.
Menu
3. Press Type from the bottom menu.