GW Instek MSO-2000EA - Sweep

MSO-2000E & 2000EA User Manual
236
Set the Hop Freq
5. Press Hop Freq to set the hop
frequency.
Hop Freq
25MHz ~ 0.1Hz
FSK Rate
6. Press FSK Rate to set the rate at
which the waveform switches from
the carrier and hop frequency.
FSK Rate
1Hz ~ 200kHz
Exit FSK Settings
7. Press Go Back to exit the FSK
settings.
Sweep
Background
The Sweep function can be used with sine, square
and ramp waveforms for either channel. The
function supports linear or logarithmic sweeping as
well as up or down sweeping.
Example
Panel Operation
1. Select the waveform from the GEN1
Setup/GEN2 Setup menu: