GW Instek MSO-2000EA - Page 127

ADVANCED CONFIGURATION
127
2. Press the BUS key.
BUS
B
3. Press Bus from the bottom menu
and choose the UART serial bus on
the side menu.
4. Press either Analog Source or Digital
Source to choose whether the
sources for the UART bus are
analog or digital.
Define Inputs
5. Press Define Inputs from the bottom
menu.
6. From the side menu choose the Tx
Input and the Rx
Input source and the signal
polarity.
Tx
OFF, CH1~CH4 or OFF, D0~D15 *
Rx
OFF, CH1~CH4 or OFF, D0~D15 *
Polarity
Normal (High = 0), Inverted (High
= 1)
*Depending on your choice at step 4 above.
Configuration
The Configure key sets the baud rate, number of data
bits and parity.
7. Press Configure from the bottom
menu.
8. From the side menu select the Baud rate, Data
bits, Parity, Packets and End of Packet bits.