GW Instek MSO-2000EA - Page 134

MSO-2000E & 2000EA User Manual
134
LIN input
GND
G
1
X
10
X
1
Analog
Digital
2. Press the Bus key.
BUS
B
3. Press Bus from the bottom menu
and choose the LIN serial bus.
4. Press either Analog Source or Digital
Source to choose whether the
source for the LIN bus is analog or
digital.
Define Inputs
5. Press Define Inputs from the lower
menu.
6. From the side menu choose the
LIN input and the polarity of the
bus.
LIN Input
CH1~CH4 or D0~D15 *
Polarity
Normal (High = 1),
Inverted(High = 0)
*Depending on your choice at step 4 above.
Note
The Sample Point soft-key indicates the sampling
position of each bit. This parameter is fixed.
Configuration
The Configure menu sets the bit rate, the LIN
standard and the parity options for the Id frame.