MSO-2000E & 2000EA User Manual
136
3. Press the Bus soft-key and select
Parallel from the side menu.
4. Press Define Inputs from the bottom
menu.
5. Press Number of Bits from the side
menu and select the number of bits
for the data bus.
By default the bus will assign bit 0
to D0, bit 1 to D1, and so on up to
the last bit.
6. You may also assign a bit as a
clock. This bit will be one of the
bits in the bus. To add a clock bit,
press Clock Edge and select type of
clock edge. Selecting Off will
disable the clock bit.
7. If you wish to define which channels are
assigned to the bus, press Select Signal from the
side menu and select the bit that you wish to
assign.
Channel 1 is
currently
assigned to bit 1.
8. Next, press Select Ch and select
which channel is assigned to the
bit selected above.
9. Repeat steps 7 and 8 for any remaining bits and
for the clock, if enabled.
To Next Page
Loading...
