GW Instek MSO-2000EA - Page 152

MSO-2000E & 2000EA User Manual
152
I
2
C
Inter-Integrated Circuit
SPI
Serial Peripheral Bus
Parallel
Parallel bus
CAN
Controller Area Network bus
LIN
Local Interconnect Network
Note
The Source Bus is not configurable from the Trigger
menu. The field is automatically filled according to the
Bus menu configuration (see page 122).
Trigger Mode
Auto (un-
triggered
roll)
The MSO-2000E/2000EA generates an
internal trigger if there is no trigger
event, to make sure waveforms are
constantly updated regardless of
trigger events. Select this mode
especially when viewing rolling
waveforms at slower timebases.
Normal
The MSO-2000E/2000EA acquires a
waveform only when a trigger event
occurs.
Single
When pressing the Single
key, the MSO-
2000E/2000EA acquires a
waveform only once
when a trigger event
occurs, and then stops
acquiring (the
oscilloscope falls into Stop
mode). Press the Single
key to acquire a
waveform again. Please
refer to Run/Stop mode
for more details (page 44).
Single