MSO-2000E & 2000EA User Manual
164
5. Use the side menu to select the pulse width
trigger source.
Channel 1 ~ 4 (Alternate On/Off),
EXT (Ext Probe: Volt/Current,
Attenuation: 1mX~1kX, CH2
models only), AC Line, D0 ~ D15.
6. Press Polarity to toggle the polarity
type.
Positive (high to low transition)
Negative (low to high transition)
7. Press When from the lower bezel.
Then use the side menu to select the pulse
width condition and width.
8. Press Threshold from the lower
bezel to edit the pulse width
threshold.
To Next Page
Loading...
