GW Instek MSO-2000EA - Page 254

MSO-2000E & 2000EA User Manual
254
Note
Frequency Coupling cannot be set if Tracking is ON.
Configuring Frequency Coupling parameters will
disable the Tracking mode.
Amplitude
coupling
15. Press Ampl Cpl to set
the amplitude
coupling to ON or
OFF.
Ampl Cpl:
OFF, ON
When set to ON, amplitude from both generated
waveforms will be duplicated from one to the
other one.
Note
Amplitude Coupling cannot be set if Tracking is ON.
Configuring Amplitude Coupling will disable the
Tracking mode.
Reset the phase
16. You can also reset the phase to 0°
between the two waveforms by
pressing S_Phase.