hager FWB Series - Page 10

10 We reserve the right to make changes of a technical nature
Technical data
Protection classes
- IP44 with door (plain, transparent or multimedia non-slotted) and IPx4 standard lock FZ598N
- IP43 with door (plain, transparent or multimedia non-slotted) and IPx3 lock FZ598
- IP31 with door (slotted, or multimedia slotted)
- IP30 without door with covered internal panels. IP30 without door from factory is only ensured when
distribution panels are inside.
Note:
- Take note of the protection class of the equipment.
Impact protection
- IK09 all around with plain door, except flange (excluded in the Standards)
- IK07 for slotted, transparent or multimedia door
- IK05 for cabinet with internal system, without door
Colour
- Door, exterior walls, covers and internal insulation: RAL 9010 (pure white)
- Metal parts of the internal system: grey and hot-galvanised
- univers Z fixing towers: black
Equipment
- Door and cabinet walls:
- Made of steel, 1 mm thickness
- Powder-coated with epoxy polyester paint, burnt in
- Insulating parts material:
- Polystyrene (PS): covers, top / bottom parts, rear, sides
- Polycarbonate / Acrylester-Styrol-Acrylnitril (PC / ASA): corners, multimedia plate
- Polycarbonate (PC): multimedia door inserts
- Acrylnitril-Butadien-Styrol (ABS): sealing plug
- univers Z mounting towers material:
- Polyamide6 (PA6): bottom parts, double towers
- Polycarbonate (PC): top parts
- Blue seal made from Ethylene-Propylene-Dien (EPDM)
- Mounting rails and DIN rails made from hot-galvanised steel, 1 mm thickness
- Multimedia steel beams (patch panels) made from hot-galvanised steel, 1.5 mm thickness
- Multimedia perforated metal plates made from hot-galvanised steel, 1 mm thickness
Plastic parts in direct contact with the area behind the wall, e.g. corners and top and bottom parts pass the
heat filament test at 750°C. The cabinet is therefore unsuitable for hollow wall application (850 °C required).
Summary of standards and regulations
- Tested in accordance with EN61439 -1/-3 (VDE0660-600 -1/-3)
- Dimensions in accordance with DIN 43780
- IP44 degree of protection in accordance with VDE 0470, part 1 (DIN EN 60529)
- Protection class IP3X with open or without door
- Clearance and creepage distance in accordance with VDE 0110, part 1 and 2/1.89
- Rated isolation voltage: AC400V
- Overvoltage category III
- Pollution degree 2
- Insulation material class I
- Unsuitable for hollow wall application