8 We reserve the right to make changes of a technical nature
For your safety
2.2 Authorised sta requirements
- Switching device combinations must always
be
installed, commissioned, expanded repaired, maintained,
removed and disposed of
by qualified electricians.
- Qualified electricians must have experience in initial
testing as well as subsequent commissioning, repairs
and maintenance.
Product life phase Minimum vocational training, qualifications or skills
Planning Qualified electrician, consultant electrical engineer
Transport, assembly, instal-
lation
Qualified electrician
Commissioning Qualified electrician with experience in testing
Operation Short-circuit devices for operation by inexperienced sta
within distribution boards for operation by inexperienced
sta in accordance with EN 61439-3 (DBO)
All additional components must be secured against use by
inexperienced sta.
Inspection and maintenance Qualified electrician with experience in testing
Expansions Qualified electrician, planning and documentation required
Removal and disposal Qualified electrician, for mechanical and electrical work
with specific instructions only: person instructed in work
on electrical installations
-
A qualified electrician is able to assess the work assigned to them and recognise potential dangers
thanks to their vocational training, knowledge and experiences as well as knowledge of the relevant
regulations.
- A person instructed in work on electrical installations must be suciently instructed and supervised by a
qualified electrician. The instructed person must therefore be able to recognise risks and prevent
dangers arising from electricity.
- All persons who are not qualified electricians and who have not been instructed in working on electrical
installations must be regarded as persons inexperienced in working with electrical installations. Persons
inexperienced in working with electrical installations must never work inside electrical installations on
their own and independently. Persons inexperienced in working with electrical installations may only
operate short-circuit devices that are intended for operation by inexperienced persons in accordance
with EN61439-3.
To Next Page
Loading...
Need help?
General
