Adjustments and tool changes
1.3 Tool change
1.3.1 General information relating to saw blades and grooving tools
NOTICE
Danger of collision when using grooving tools
Damag
e to the grooving tools and machine table.
− Do not adjust the 90° angle when working with grooving
t
ooling.
− A spacer ring has to be placed onto the saw arbour before
usin
g grooving tooling with a width measuring less than 10
mm.
Fig. 6: Anti-rotation saw shaft
1 Saw shaft diameter
2 Anti-rotation saw flange
Only use saw blades and grooving tools,
● which have an authorised speed higher than the speed of the saw arbour
● and comply with the norm DIN EN 847-1
● which are marked with "MAN"
Onl
y use grooving tools,
● which are suited to manual operation
● which are suitable to work with wood
N
ote
We recommend you use manufacturer original Felder Group tools
exclusively.
The processing of workpieces at the maximum cutting height indicated is only
possible under certain conditions. Whether it is possible is in direct relation to the
following factors:
● Type of wood (hardwood or softwood)
● Wood dampness
● Feed speed
● Saw blades
● The motor power of your machine
To Next Page
Loading...
