Hammer K2 M - Remove the Rip Fence; Mounting the Sägeboy Auxiliary Fence to the Rip Fence

7
K2 M - Part 2/2
Adjustments and tool changes
1.1.3 Remove the rip fence
1
2
3
Fig. 3: Remove rip fence
1 Thumb screw 1 (clamping of the fence plate)
2 Clamping screw 2 (clamping the rip fence)
3 Fence support bar
When processing large panels or when carrying out maintenance work it may be
nec
essary to remove the rip fence.
1.
Tighten thumb screw 1.
2.
Loosen thumb screw 2.
3.
Push the rip fence right to the back.
4.
Lift the rip fence slightly and pull it backwards off the fence support bar.
1.1.4 Mounting the "Sägeboy" auxiliary fence to the rip fence