Hammer K2 M - Grooving Tools; Retooling to an Operation with Grooving Tools

20
Adjustments and tool changes
1.5 Grooving tools
1.5.1 Retooling to an operation with grooving tools
1
2
3
4
Fig. 16: Rear flange / riving knife holder / insert board
1 Insert board
2 Rear flange
3 Flange for circular saw blades
4 Riving knife removed
WARNING
Sharp and hot tool cutting edges
Cuts and burns due to sharp and hot tools.
− Wear protective gloves.
− Adjustments to the machine or changing the tools may only be
done onc
e the machine has stopped.
Tool:
● Spanner 17 mm
1.
Preparing the machine for a tool change. ⮫
Chapter 1.3.2 ‘Prepare to
change tooling’ on page 11
2.
Remove insert board.
3.
Remove the saw blade.
4.
Remove the riving knife.
5.
Remove the rear flange.
6.
Position the saw aggregate in the 90° position (cutting angle 0°).