4.
Remove the cover plate from the front side:
Loosen the wing nut inside the machine.
T
he wing nut can be reached from the rear side of the machine.
Push the cover plate upwards and remove it from the front.
5.
To reassemble, follow the instructions in the reverse order.
🡆
The respective cover plate must be in contact with the machine chassis on
all side
s before tightening it.
3.3 Cleaning and lubricating
● Do not use compressed air to clean, as this will blow dust and shavings into
the v
arious ball bearings and guides.
● Only use low dust emission vacuum to remove dust deposits.
● Carry out cleaning when required, after each workday or at the very latest
af
ter 8 hours of operation.
NOTICE
Caustic or abrasive cleaning detergents
Damag
e to the surface of the machine
− Never use caustic or abrasive cleaning detergents.
Note
Cle
aning and care products are available as accessories (see:
Tools and accessories catalogue / Online shop: www.felder-
shop.com).
3.4 General maintenance procedures
3.4.1 Clean the machine thoroughly
CAUTION
Sharp tools
Cut in
juries
− Use tools carefully.
− Wear gloves.
− Use safety equipment.
Personnel:
● Trained machine operator
Pr
otective equipment:
● Protective clothing
T
ool:
● Cleaning cloths
● Vacuum cleaner
1.
Switch off the machine and secure it against being switched on again.
To Next Page
Loading...
