● Covered cuts / rebate on the parallel cutting fence.
● Covered cuts / grooves on the parallel cutting fence with grooving tools.
2.3.3 Prohibited working methods
T
he following working processes are prohibited on this panel saw:
● All work techniques without the use of the parallel cutting fence, crosscut
f
ence or trimming unit.
● Cutting of round workpieces (in the longitudinal direction).
● Removing the riving knife for insert cuts *).
● Covered cuts *).
*) T
he following deviations apply to the scope of the Holz-Berufsgenossenschaft
(BG) in the Federal Republic of Germany: Insertion cuts and covered cuts are
permitted if the operating regulations corresponding to the Employer's Liability
Insurance Association (BG) are observed (BG No. 96.18).
2.3.4 General procedures for authorised working techniques
Note
When using appropriate auxiliary equipment and observing the
safety distances to the surroundings, there are no limits to the
workpiece dimensions.
CAUTION
Spinning of round workpieces
In
jury from flying workpieces and parts of the workpieces.
− Secure round workpiece against turning by using a template or
holdin
g device.
− Work with the crosscut fence especially with round work-
piec
es.
− Use a suitable saw blade for cross sections.
1.
Switch the circular saw off prior to starting work.
2.
Ensure that there are sufficient support surfaces (accessories).
3.
Keep handling accessories at hand:
● Push stick, push grip
● Deflector with holding magnets
4.
If required: Set the cutting height, cutting angle and if necessary scoring
blade
.
5.
With machines that have an overhead saw guard:
For angle cuts, convert the circular saw top guard to the wide
guar
d.
Lower the protective hood to the workpiece height.
6.
Before cutting check the collision zone between crosscut fence and saw
blade
.
To Next Page
Loading...
