Hammer K2 M - Longitudinal Cut; Cutting of Strips

29
K2 M - Part 2/2
Use
7.
On machines without extraction system control, switch on the extraction
s
ystem.
8.
Only switch the machine on once the workpiece has been placed in the
c
orrect position.
9.
Feed the workpiece evenly past the saw blade, keeping your fingers balled
int
o a fist.
10.
Use the push stick once you are at the end of the cut.
11.
Once the cut is finished, switch the machine off.
2.3.5 Longitudinal cut / cutting of strips
1
2
3
Fig. 24: Rip cut
1 Saw blade
2 Fence plate (guide)
3 imaginary 45° line
3
Fig. 25: Cutting strips